Liner still present after HOT burn...ideas???

Discussion in 'UDS Builds' started by half baked, Apr 23, 2010.

  1. half baked

    half baked Newbie

    measured and cut the intake holes and Burned burned burned.....YET....the damn liner didnt budge.

    Any further ideas on getting this liner off?????

    I already have the sandblasting co. ready for it once its burned BUT its no different on the inside.

    Thanks,
     
  2. placebo

    placebo Smoking Fanatic OTBS Member SMF Premier Member

    Welcome to SMF. Stop in the roll call and tell us a bit about yourself.

    What kind of drum did you get? Sounds like it might be one of those food grade drums used for honey that have the lining on the inside. Maybe sandblasting can remove the liner. I've never tried to burn one of those out yet. Thought I was going to be able to try but the ones on craigslist sold out before I could get one.[​IMG]
     
  3. ddave

    ddave Master of the Pit OTBS Member SMF Premier Member

    Sandblast or wire cup on an angle grinder. They are TOUGH to get out. I've heard an abrasive wheel for removing paint works.

    Dave
     
  4. pandemonium

    pandemonium Master of the Pit

    Yes the abrasive wheel on a grinder worked better that the wire cup brush in my opinion, buy buy both types, they both work just the abrasive one seems to work quicker. if you have a harbor freight tools near you they are way cheaper there than at home depot.
     

Share This Page