Installing aftermarket thermometer

Discussion in 'General Discussion' started by bobcats110, May 31, 2013.

  1. bobcats110

    bobcats110 Fire Starter

    I have a WSM 18.5" that I want to install a thermometer in the lid so I don't have to keep opening it to see the over thermometer that I'm currently using.  Any advise on drilling a hole, and where, to get the most accurate readings?  Don't want to mess it up by trial and error.

  2. you might go to a Lowe's and measure a newer 18" that has a therm built in.  Are you going with Teltru?
  3. fwismoker

    fwismoker Master of the Pit

    Last edited: May 31, 2013
  4. sqwib

    sqwib Smoking Guru OTBS Member

    Mine are dead nuts on
    I rely more on them than my maverick.
    My maverick is best when I'm mobile.

Share This Page