Grommets from maverick for et 732

Discussion in 'Charcoal Smokers' started by brgbassmaster, Feb 9, 2015.

  1. brgbassmaster

    brgbassmaster Meat Mopper

    Last edited: Feb 9, 2015
  2. handymanstan

    handymanstan Smoking Fanatic Group Lead

    Last edited: Feb 9, 2015
  3. jckdanls 07

    jckdanls 07 Master of the Pit Group Lead OTBS Member

    link not working for me....
     
  4. brgbassmaster

    brgbassmaster Meat Mopper

    Thanks stan appreciate it very much.
     
  5. cmayna

    cmayna Master of the Pit OTBS Member SMF Premier Member

    You can buy those type of grommets at your local automotive parts stores.  Called firewall grommet. 
     
    Last edited: Feb 10, 2015
  6. one eyed jack

    one eyed jack Master of the Pit

    I realize that it's a bit crude compared to the grommet's, but I simply drilled a 7/16 hole, (With a "step drill".   ),  through my kettle's and WSM.  Originally intended to look for a grommet to finish it but have had no troubles so far.  The step drill will start a hole, without need of a center punch which can shatter the coating on the Weber kettle's and WSM's, and cut's a clean hole that doesn't need additional de-burring.

    I have used these smokers for an average of two smokes per month for over two years with no adverse effect to the probe wires of either my Maverick nor Thermoworks thermometer probes.

     

Share This Page