grinding the lid on my 55 gallon drum

Discussion in 'UDS Builds' started by sniltz, Jan 16, 2011.

  1. sniltz

    sniltz Meat Mopper

    I am planning to make a UDS and the drums I have (4 of them) are from a bakery.  They have had canola oil in some and molasses in the other.  The question that I have is they are not a removable lid, they are a close lid.  How do I grind the lid off so that I can reuse the lid for my UDS?   What grinder do I use?  Do I use a standard grinder, a drimmel, I just don't know.  Any suggestions would be great.  Thanks.
     
  2. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Use a thin cut off wheel on a grinder. Think about cutting the drum 1" below the end. Then maybe expand the 1" lip outward so it overlaps the drum or expand the sides outward so the lid fits inside the drum walls. This can be accomplished with two hammers using one for support. It will take time and may be a solution to consider.
     
  3. smokeamotive

    smokeamotive Smoking Fanatic

    A die grinder and a 3" cutoff wheel should do the trick. Hammer down any edges that are sticking out as these will be quite sharp. I have see people use a Weber kettle lid as the top of their UDS.
     
    Last edited: Jan 16, 2011
  4. dburgette

    dburgette Fire Starter

    I did the same thing with my smoker, but didn't reuse the lid. I now use the weber top as the lid. This will also give a little breathing room for the top rack.
     
  5. el ropo

    el ropo Newbie

    I used a 1/2" cold chisel and a hammer, took about 5 min. per drum.

    [​IMG][​IMG][​IMG][​IMG][​IMG][​IMG]

    It just occurred to me that this may be my first post here.  Hi all!
     

Share This Page