Discussion in 'Slicers, Grinders, Tools, Equipment' started by wingnut, Dec 17, 2011.

  1. I have a friend that is going to 'revamp' an older style, cast iron  hand crank grinder with a 3/4 HP motor.

    Now the motor turns at about 3400 rpms and he has on order a pulley that will fit the grinder shaft.  The problem that I see is that the grinder will be turning at about 850 rpms.

    To me that seem a bit too fast, I'm thinking about 300 to 350 any thoughts??

    TIA Larry
  2. venture

    venture Smoking Guru OTBS Member

    PM sent.

Share This Page