Got My Sear On!!!!

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

wolfman1955

Master of the Pit
Original poster
Nov 17, 2013
1,054
47
Chillicothe, Ohio
Oh yes you can sear a steak on a pellet smoker!!



I cold smoked these Rib Eyes for 1.5 hours with Hickory. Removed from the Yoder, then started the beast up!

Set point to 600, 30 min. later slaped the meat on the rack. I did'nt even use the grill grates and left the deflector plate in. Still got these great sear marks.

Oh by the way I am not a total Carnivore.


Hope you enjoyed lookin as much as I did eatin!!!

Keep Smokin!!!

Wolf
 
Great lookin steaks & meal ! I really like my pellet smoker, it's fun to use....

Again, nice job !
 
All,
Thanks for the replies!!
As I said in my post I didn't use the grill grates and left the diffuser plate/drip plate in!!
OOOPs my bad I just got off of the Yoder web site forum and the guy Yoder_Herb that kinda runs there forum said that you should not run your Yoder above 375 with diffuser in cause it will warp the plate!! Ok then it gives an easy fix to corect it. SO DO NOT SEAR STAKES WITH THE DEFUSER IN!!!
Keep Smokin!!
Wolf
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky