My fridge build is done minus the heat source. I have all components except for the heating element. My local supply place has stove burners that run on 110 (my preference since I don't want to mess with 220) I plan on using 2 in a series circuit. My question is how do I mount them into my fridge. I was thinking of cutting two holes in the bottom but that is still not a mounting surface. I: am new to building metal anything so any input would be greatly appreciated. I tired a hotplate but that only worked a few times. These pictures are just to give some idea of the size of my work area. Thank you for all your brilliant ideas. P.S. I am hoping to be done with this completely by the end of the week so I can have a few friends over for some BBQ.