Dumb question- Maverick Thermo

Discussion in 'Meat Thermometers' started by pacedawg, Nov 18, 2013.

  1. pacedawg

    pacedawg Fire Starter

    I cannot for the life of me find the answer to my question while searching this forum so I apologize if I am asking a question that has been aswered a thousand times. Can someone tell me/ show me the best way to set up a Maverick ET-732 on a Brinkmann Offset? Do I need to make any mods or can I run it through the vent, etc? Also, can someone explain the usage of the potato or wood? Last, does the Maverick take readings for the meat while cooking and the internal temp of the grill?
     
  2. I drilled a 3/8" hole in the end of my smoker base ( opposite end from firebox). I run the probea through there. Some people would aay that's a large hole for a leak, but it's a Brinkmann what's another leak between friends. Just don't pinch the probe leads.
     
  3. davidhef88

    davidhef88 Master of the Pit OTBS Member

    The ET732 has dual probes one for the meat one for the smoker.  Two separate readings on your remote.  I don't know what i'd do without mine.
     
  4. venture

    venture Smoking Guru OTBS Member

    On my offset, no drilling was necessary.

    I wrap a little aluminum foil around the wires for some mechanical protection.  Gently close the lid.

    The Maverick pit probe comes with a clip for the grate, so no potato or wood contraption is necessary.

    Good luck and good smoking.
     
    Last edited: Nov 19, 2013
  5. pacedawg

    pacedawg Fire Starter

    Thanks for the help!
     
  6. danbono

    danbono Master of the Pit OTBS Member

    Hi I wouldn't smoke/cook without using my Maverick 732..I even use it indoors. Best $$ spend on any smoking tool. I too have a Brinkmann Offset no problems with the probes. Get one you won't be dissapointed.

    Dan
     
  7. pacedawg

    pacedawg Fire Starter

    Dan- how are you running the probes?Are you just closing the lid on the wires? Thanks for the reply!
     
  8. danbono

    danbono Master of the Pit OTBS Member

    Yup just closing the lid on the probe wires.

    Dan
     

Share This Page