Drilling a hole for ET-73

Discussion in 'Propane Smokers' started by johnnyo, Jan 26, 2007.

  1. Hi, I got a Big Block coming.. Can I just drill Holes for inserting the probes for the ET-73, rather than inserting them through the chimney?
     
  2. pigcicles

    pigcicles Master of the Pit OTBS Member SMF Premier Member

    johnnyo - it's your show, you can do whatever you like with your smoker. But before you go drilling a hole in your GOSM, What concerns do you have that you would want to drill the hole instead of using the vent? There are many ways to get around problems, we'll help you find a good solution.

    Keep Smokin
     
  3. Thanks for your reply PigCicles.. Really no huge concern , only a couple of dumb thoughts.. one is the ditance for the probe wires to go, a foot or so to the chimney hole, then down to the ham or whatever on the bottom rack.. I was going by the old theory of mine, shortest distance between 2 points.. Second, I read somewhere on this forum that there were some concerns of the probe wire getting too hot, & to be careful.. so again I figured the chimney might get pretty hot.. Just trying to figure things out ahead so I don't screw something up..
     
  4. vulcan75001

    vulcan75001 Smoking Fanatic OTBS Member

    johnnyo
    Hello there... I use the et-73 myself and have never had any problems with the probe wire....if you are concerned about the wire being too short..maverick has probes with 6' wires...check their web site...or if you still have the instruction sheet...they are listed there...

    Later
    Richard
     
  5. larry maddock

    larry maddock Master of the Pit OTBS Member

    yo johnyo,
    theres no better approach--
    than thinking ahead.
     
  6. Johnnyo.
    I drilled a small diameter hole in the back of my smoker like you are wanting to do probably to keep the probe wire out of your way. Just drill the hole large enough so you can insert the probe with .003 clearance or so for example.
     
  7. Thanks all, yup I'll order the 6 Ft. probes... living in the land of 1 month summers & 11 months of tough sledding, I think I'll be looking at putting insulation on the outside in the future.. And reading about others putting insulation on & screwing it on, I kinda figured "what's one more hole",(no pun intended), of course that was before I got all your answers here.. now I just have to wait for it.. in the meantime, back to my little old wooden crapper style smoker, not fancy but it smokes..
     
  8. oillogger

    oillogger Meat Mopper OTBS Member

    I own the ET-7 and Big Block. I have only used the top vent on my Big Block to insert the ET-7 probes thru and never had a problem reaching the lowest cooking grate. There should no need to drill holes in your new smoker.
     
  9. dutch

    dutch Smoking Guru Staff Member Administrator Group Lead OTBS Member SMF Premier Member

    johnnyo- if you plan it right, mount the insulation where the mounting bolts for the rack supports are-You'll need to use a longer bolt to allow for the insulation and you don't have to worry about drilling any extra holes.
     
  10. Thanks Oillogger, & Dutch , you should put Whiz in front of your name.. Great idea.. NOW, judging by the pics, the shiny part goes against the smoker, and the joints are all covered with the silver tape.. How about the insulation, will it get weathered bad?
    looks like the blue plastic or paper is to the outside..
     

Share This Page