Direct Offset to Reverse Flow Conversion

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

xxsmokedoutxx

Fire Starter
Original poster
May 27, 2015
45
38
Phoenix, AZ
I'm new to the forum, but it looks like there's a ton of available knowledge here.  I recently bought an Oklahoma Joe's Highlander Offset Smoker, and knew I would be doing a few mods right off the bat.  I did a stock trial run just to see where the leaks were and how large of a variation there was in temperature throughout the cooking chamber. Needless to say, there was quite a lot of difference and leaks. As I began to research heat distribution methods, I ran across Reverse Flow Smoking. The work won't cost me anything, but I still was wondering if it would be worth converting. Has anybody done a project like this? Any suggestions? 
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky