Converted stainless steel pie cabinet

Discussion in 'Other Builds' started by uncleob, Jun 7, 2014.

  1. This is some pictures of my smoker.

    Inside is 37''H X 13''W X 22'' D

    Smoke stack is 3'' X 20'' stainless steel tubing.

    The bolt for the butterfly valve 3/8 X 8'' stainless eye bolt with stainless washers and nuts, bolt is ground down a little over half way with a angle grinder. The disk is from the hole saw hole from drilling the cabinet.


    To brace the tubing to the cabinet i had a unused garbage disposal sink insert that fit perfectly, all screws are stainless 10 X24 drilled and tapped.

    I replaced the door gasket with a 7/8 fiberglass rope gasket and covered with 400 degree silicone to keep the stray fiberglass strands out of the food.

    I replaced the broken old thermometer with a  2'' River Country unit.

    The heat comes from a removable 1500 watt fan forced unit that came with the cabinet. I had to replace the fan and motor due to it being damaged by someone trying to fix it before i got it.I also replaced the thermostat due to the same reason i used a 50 - 250 centigrade unit I, also added a speed controller for the cabinet fan and a small exterior fan to cool the main fan motor and it also pumps some fresh air into the cabinet for the Todd`s smoker tray.





    With the heating unit removed.

    I added a piece of stainless for the bottom of the door to seal against.The unit sets on 4'' swivel casters.

    .This was a fun build and I hope you enjoy the pictures. ; )
     
  2. Hello.  GREAT lookin rig.  Some nice ideas incorporated into that.  Have fun with it!  Keep Smokin!

    Danny
     
  3. moikel

    moikel Master of the Pit OTBS Member

    Nice work, great bit of recycling. You obviously have some serious skills.
     

Share This Page