Chuck Underblade w/ Qview

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

cheyman

Fire Starter
Original poster
Jul 30, 2008
35
10
Fitchburg
Well, I have yet to attempt any beef, and after I saw a thread from Reddog, and advice from Geek w/ Fire, I decided to try. So I went out this morning and got a cuck roast. I bathing it with Beamish, brown sugar, garlic salt, S&P and chopped onion. I plan on mopping it with the bath.



Got the meat from BJ's



For the bath



Going to soak it over night. I also injected it with some Beamish.
 
Are you going to attempt to pull it? This is the chuck my butcher reccomended for pulling, so I will be following this thread, as I have two of them in the freezer.
 
I'm not sure yet. I read that this was good for pullin' but I think I'll just see how it comes out & decide then. I'm pretty flexible either way.
 
It will be good either sliced or pulled. I just found out there are 7 types of chucks and have done several of them to find out some pulled, some partial pulled and some didn't pull at all. Either way they were still tasty.
PDT_Armataz_01_28.gif
 
Brine looks really good. Didn't notice a fat layer on it, how lean was the cut? May want to wrap some bacon around it to give it some fat ... IMHO
PDT_Armataz_01_28.gif
 
I'm 3 hours in to my smoke. I reduced the marinade and have been mopping it every 45 mins. Temp is 151. I'll take a pic next mopping.
 
Ok here's the beef. temp is 153. 3 hour 20 mins into. When should I take it off? 175? Higher?
 
175 would be good for sliced beef. Not sure if you removed it sooner, it may still be alittle on the tough side.
confused.gif

Looking forward to your report.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky