Casings Problems Solved

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

danbono

Master of the Pit
Original poster
OTBS Member
Feb 19, 2012
1,702
115
North New Jersey Paramus
Hi All I just had a very HARD time getting casings 32/35mm on my 1/2 Grizzly stuffer tube..The little veins inside the casing would not let me slide the casing on center . The casings were going an a angle ..
So here is what I did to solve the problem at least for now..I started the casing got a couple of inches on , then I put the other end around my faucet, ran some water to open the casing, they went right on.. Had to let the water drain out before stuffing.
Next time I buy casing it will be the tubed kind.Should be much easier!!

Dan
 
Last edited:
Sausage looks great Dan.. ........
icon14.gif
       Glad you figured out the casing problem... Were they veins or more like tags....?
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky