carving whole chickens

Discussion in 'Poultry' started by cyclonesmoker, Feb 3, 2011.

  1. cyclonesmoker

    cyclonesmoker Fire Starter

    I am preparing to smoke a couple whole chickens on Sunday....I'm looking for advice on carving. I've never smoked a whole chicken nor have I ever carved one. Any suggestions would be appreciated. Any helpful tips on smoking the chicken would be good too. Thanks!
     
  2. alblancher

    alblancher Master of the Pit Group Lead OTBS Member

    That's a lot of questions with very detailed answers.  I'll try to point you in the right direction.   First thing I would do is check out Travis' poultry brine in the Wikis.  He has a recipe for a reliable poultry brine, injection and rub.  They will give you a good first step

    You smoke a chicken the same was as a turkey, they just finish sooner.   If you can get your smoker to 300 degrees you can probably finish the chickens in the smoker in about  two hours. 

    If not go ahead and smoke the poultry 2 or three hours and then move to a 350 oven to get to recommend internal temperature of 165 degrees

    I like to smoke poultry at a higher temp initially to get beyond the danger zone and then lower the heat to let smoke.  That way I can let it sit in the smoker a bit longer once it gets to an internal 140 degrees.

    As far as carving I am sure if you do a search they will have a video for you but to break it down into a couple of easy steps.

    Remove the wing where the joint attaches to the back bone.  Pulling the wing away from the breast will make it easier to find the joint.

    Remove the drumstick/thigh at the knuckle with the backbone.  Pull the thigh away from the breast and slide your knife into the joint.  This will give you the dark meat of the bird.  You can separate the drumstick from the thigh if you like.

    Next thing I do is cut down alongside the breast bone removing the breast from the carcass. 

    The rest is just recovering the little pieces still attached to the carcass.  If smoking I wouldn't worry about serving the back as a separate piece.

    Good Luck

    Hope this helps

    Al
     
  3. smokinal

    smokinal Smoking Guru Staff Member Moderator OTBS Member ★ Lifetime Premier ★

    What Al said, and when you remove the breast slice it cross grain. Don't forget the Qview.
     
  4. chef willie

    chef willie Master of the Pit OTBS Member

    Great advice above...new here myself so absorb all the advice I can get. One thing I could offer would be to use the carcass bones for soup stock after. I've done turkeys in my funky ECB before and making stock for soup or a batch of Gumbo with those smoked bones is excellent and a real treat.
     
  5. mballi3011

    mballi3011 Smoking Guru OTBS Member SMF Premier Member

    [​IMG]

    The easiest way to carve a chicken is to watch someone do it. Now since I can come over to your house right now I would recommend that you go to You-tube and just type in carving a chicken and boom there you have a boat load of videos on how to. Good luck and watch out the your finger tips.
     
  6. arnie

    arnie Smoking Fanatic

    What part of Iowa you from?

    I would strongly recommend that you bring it to my house after you smoke it.

    I could carve it for you for a taste or two.
     
  7. cole

    cole Fire Starter

    Most of the time I don't necessarily cut it.  I will let it cool for 15-25 (so the juices don't just run out) minutes and then start pulling the meat off by hand it will almost look like pulled pork.  You can yield a lot more of the meat that way it seems to me.  Good luck, I'm doing chicken and ribs for Super Sunday.  
     
  8. pull the leg quarters away from the body and lay on platter

    pull the wings off of the body and lay on platter

    pull the whole breast away from the ribs-backbone and lay on platter

    repeat for next chicken

    serve the platter to family/guests

    if they don't eat at least a quarter each, it wasn't cooked right or wasn't seasoned right

    oh-

    the cook eats all the meat off the backbone (oysters and tenderloins - the best part) while "carving" (above)

    enjoy
     
  9. cyclonesmoker

    cyclonesmoker Fire Starter

    thanks! I pulled the chicken off by hand and got a ton of meat. Thanks again
     
  10. smokinal

    smokinal Smoking Guru Staff Member Moderator OTBS Member ★ Lifetime Premier ★

    Yea you can't beat pulled chicken!
     
  11. scarbelly

    scarbelly Smoking Guru OTBS Member

    Pulling by hand is another good way with smoked chicken - glad it turned out good for you
     
  12. alblancher

    alblancher Master of the Pit Group Lead OTBS Member

    Yea, but jerked chicken is a whole other recipe!
     
  13. buckeye024

    buckeye024 Smoke Blower

    Quote:
    Now that's funny right there!
     
  14. buckeye024

    buckeye024 Smoke Blower

     
  15. pops6927

    pops6927 Smoking Guru Staff Member Moderator Group Lead OTBS Member SMF Premier Member

  16. smokinal

    smokinal Smoking Guru Staff Member Moderator OTBS Member ★ Lifetime Premier ★

    Your right Al, love that heat!
     
     

Share This Page