brinkmann pitmaster mods

Discussion in 'Smoker Builds' started by tim yoder, Apr 3, 2014.

  1. tim yoder

    tim yoder Fire Starter

    hi all today i started work on my brinkmann pitmaster we did all of the design work and ordered the metal for it using expected metal for the charcoal basket and 1/4 inch metal for the baffle and turning plates





     
    Last edited: Apr 4, 2014
  2. Hello Tim.  Lookin good so far.  Good luck.  Keep Smokin!

    Danny
     
  3. tim yoder

    tim yoder Fire Starter

    hi guys well i got my metal parts today we are about done on the smoker build the baffle plate is made out of 3/16 metal and the tuning plates are made of 1/4 metal need to finish the front shelf and brace the legs and extend the chimney down to grate level and replace the wheels and repaint it then put the seal on then i am done i am so happy right now  i did fire it up today i could the the difference right away it was amazing















     
    Last edited: Apr 16, 2014
  4. tim yoder

    tim yoder Fire Starter









     
  5. aaardvark

    aaardvark Newbie

    Tim:

    Looks great.  I am about to start a restoration of a BPD and want to make the same mods.  Do you happen to recall the measurements for the heat shield.  Top I can figure out, but 1) bottom and 2) some way to guesstimate the curve would be very helpful.
     
  6. tim yoder

    tim yoder Fire Starter

    hi there i will try and help u the best way i can a email address or phone number that would be grate and make sure to use only dry wood is what i found works the best
     
  7. aaardvark

    aaardvark Newbie

Share This Page