amnps in a master forge vertical smoker

Discussion in 'Propane Smokers' started by beefy bill, Nov 19, 2014.

  1. beefy bill

    beefy bill Meat Mopper

    Hey everyone. I am interested in the AMNPS. I have a master forge vertical smoker. There is a cylindrical cover over the burner with 3 slots that allows heat through the top, where the chip box sits, and slots around the sides. Can I sit the amnps in the same place as the chip box?
     
    Last edited: Nov 19, 2014
  2. sqwib

    sqwib Smoking Guru OTBS Member

    You could put it on top of the chip box.

     
    Last edited: Nov 19, 2014
  3. sqwib

    sqwib Smoking Guru OTBS Member

    I don't know why all my videos are playing, just stop it after the first video.
     
  4. beefy bill

    beefy bill Meat Mopper

    I'll have to check when I get home, but I think the water pan will be in the way.
     
  5. beefy bill

    beefy bill Meat Mopper

    The water pan is only 3 or 4 inches above where the chip box sits. With the chip box in place it won't fit. Can the amnps not be placed so close to the heat source?
     
  6. cmayna

    cmayna Master of the Pit OTBS Member SMF Premier Member

    Is this a propane smoker?
     
  7. beefy bill

    beefy bill Meat Mopper

    yes it is. I've also discovered the amnts. If I use that on the grate, next to the meat, will that meat get smokey?
     
  8. beefy bill

    beefy bill Meat Mopper

    SQUIB, what kind of smoker is that?
     
  9. tjohnson

    tjohnson Smoking Guru Staff Member Moderator Insider OTBS Member SMF Premier Member

    I would use the Tube Smoker in your propane smoker

    Larger mass of pellets performs better in the low oxygen atmosphere of a propane smoker

    The smoke circulates, so your meat shouldn't get too smokey
     
  10. cmayna

    cmayna Master of the Pit OTBS Member SMF Premier Member

    I have a masterbuilt gasser and have the amnps supported under the bottom of the smoker's burner.  The heat draws the smoke of the amnps upward into the smoker.
     
    tjmitche likes this.
  11. beefy bill

    beefy bill Meat Mopper

    Now that's an idea....I imagine I gotta get it pretty close depending on wind...I'm gonna go eye that up in a little while...
     
  12. cmayna

    cmayna Master of the Pit OTBS Member SMF Premier Member

  13. beefy bill

    beefy bill Meat Mopper

    That's slick. I gotta go see if I have the claearance. I looked for specs on the height of the amnps. I only find length and width. How tall is it?
     
  14. cmayna

    cmayna Master of the Pit OTBS Member SMF Premier Member

    [​IMG]
     
  15. sqwib

    sqwib Smoking Guru OTBS Member

    GOSM Big Block
     

Share This Page