Adding fat to a lean trimmed brisket.

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

flyinlizard

Fire Starter
Original poster
I was recently given a very trimmed, rolled and tied brisket flat of about 5 lbs.  It has no flat cap at all.  Could I get some beef fat from a butcher and lay it on top of the meat so it melts during smoking or should I just use that other cooking utensil called a,,   crock pot,  I know blasphemy.
 
If you're cooking this low & slow, I suggest you un-tie and unroll it. That's a possible food safety issue, otherwise. If it's rolled, it's meant for a bit hotter, faster cooking. Added fat to render down will add flavor and make it less dry eating. You could drape some nice bacon over the top, instead...works wonders on a lean-trimmed pork loin...never tried it on lean-trimmed brisket (yet...LOL!!!).

Eric
 
Last edited:
Laying a layer of fat to a lean, trimmed hunk of meat is called Barding. It is a classic technique that works well. Don't forget to add Rub under the fat. It gives lots of flavor. When the IT hits 170°F, pull the fat off and get some bark on the top of that brisket...JJ
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky