2 questions about RF plate

Discussion in 'Reverse Flow' started by sela86, May 17, 2015.

  1. sela86

    sela86 Newbie

    1. How much of a gap should be between the end of the RF plate and the end of the cooking chamber( as in how long should the RF plate be)?

    2. Does it matter how thin the metal is for the RF plate?

    I'm converting a very old (still in good shape) brinkmanship offset to a reverse flow. At least I'm going to attempt it.

    Thanks in Advance
     
  2. smokejumper

    smokejumper Smoking Fanatic

    Hello sela86,

    The opening at the end of the RF plate should be at least as big as the firebox to cook chamber opening.

    Typically the RF plate is 1/4 inch. 3/16 is as thin as I would go.

    Hope this helps.
     
  3. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

Share This Page