1st post AMNPS mes40 question

Discussion in 'Slicers, Grinders, Tools, Equipment' started by larkinjr, Dec 8, 2015.

  1. larkinjr

    larkinjr Fire Starter

    I have a mes 40 I think Gen 2 have a slanted drip tray and vent top left of smoker. I just ordered a AMNPS 5x8 I see alot of people putting it above the water pan hole with no pan. Is that's still the best place? Or have y'all found anything better?



    Sent from my XT1254 using Tapatalk
     
  2. catabler

    catabler Newbie

    I put my AMNPS on the rods to the left of the chip box. Chip box and chip loader both pulled out about 2 inches and top vent wide open.
     
  3. If you do a search in the Electric Smoker section you will find a multitude of suggestions regard that very question as well as any others you may have.

    Plenty of knowledgeable folks here so your question will be answered shortly!

    Good luck,

    John
     

Share This Page