- Sep 3, 2016
- 6
- 10
Hi
I am in the early stages of planing my first reverse flow build.
The compressor I have purchased is somewhat bigger than what I had in mind at 1900l or 500 gallons but it was the best one I could find.
I was not planning on making a trailer but think with this tank it makes sense?
Given it is so much bigger than I had planned I though I would make the smoking chamber and firebox out of the same tank. From what I gather from the calculators if I cut the tank into a 1.5m section for the smoking chamber and a 500mm section for the firebox the proportions should be about right.
I have a mig but I figure I am really going to need a plasma cutter for this project. Any thought on if any of the cheaper cutters are worth while?
Any thoughts?
Thanks
I am in the early stages of planing my first reverse flow build.
The compressor I have purchased is somewhat bigger than what I had in mind at 1900l or 500 gallons but it was the best one I could find.
I was not planning on making a trailer but think with this tank it makes sense?
Given it is so much bigger than I had planned I though I would make the smoking chamber and firebox out of the same tank. From what I gather from the calculators if I cut the tank into a 1.5m section for the smoking chamber and a 500mm section for the firebox the proportions should be about right.
I have a mig but I figure I am really going to need a plasma cutter for this project. Any thought on if any of the cheaper cutters are worth while?
Any thoughts?
Thanks
