Search results
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
ET-73 Mod. finished...WORKS GREAT !!!
I just bought an ET-73 and it didn't work very well. I placed the transmitter outside and I couldn't get a signal through 2 walls. I did the mod today and I tested the unit by putting the transmitter on the ground beside the garage and walking everywhere in the house...signal was received...- baconisgood4me
- Post #10
- Forum: Meat Thermometers
-
UDS - Made in Canada!
I did get one picture of the pork shoulder before it went on the UDS, however it took so long to cook everyone ate it up before I got to take an after picture. LOL Next time I'll take lots of pics!- baconisgood4me
- Post #16
- Forum: UDS Builds
-
-
UDS - Made in Canada!
That is in the works already. Just need to make a template and get some more paint.- baconisgood4me
- Post #14
- Forum: UDS Builds
-
UDS - Made in Canada!
Did my first smoke on Sunday. I did a Pork shoulder. I had a heck of a time maintaining the temperature. It worked well for the first couple of hours staying around 220-245 and then went nuts and shot up to between 350-400 and I couldn't get it back down. I used lump charcoal. I think next...- baconisgood4me
- Post #8
- Forum: UDS Builds
-
UDS - Made in Canada!
Cost breakdown of this project was as follows... Barrel = $25.00 Torch Rental = $12.00 Wire Wheel = $10.00 Chef Master BBQ = $0.00 (I bought it at Canadian Tire and used CT Money to purchase it. It's regular price is $65) Expanded metal = $30.00 Paint = $20.00 Misc. (Screws, washers, pipe, ball...- baconisgood4me
- Post #3
- Forum: UDS Builds
-
UDS - Made in Canada!
I coated the inside with PAM and lit up some lump charcoal and Hickory to season it. It was cold and windy today. By cold I mean 4 °C (39 °F) and that wasn't counting wind chill as it was very windy too! It took an hour to get up to 220 °F. I had all 3 one inch vents open, at 150 °F I...- baconisgood4me
- Post #2
- Forum: UDS Builds
-
UDS - Made in Canada!
Hi all, I finally got my UDS 95% complete. I ran into some problems with finding certain pieces and not having the proper tools, but I will explain in detail with pics in case any other Great White Northerners decide to build one of these. I have only a couple things left to do to it and it...- baconisgood4me
- Thread
- Replies: 16
- Forum: UDS Builds
-
G'day from the Valley.
Thank you all for the warm welcomes. :) I started burning out my barrel tonight and will continue more burning tomorrow. I will take some pics and start posting the progress in the UDS builds section.- baconisgood4me
- Post #16
- Forum: Roll Call
-
G'day from the Valley.
G’day, my name is Mike. I’m from the Ottawa Valley in Ontario, Canada. I’ve been a lurker here on smokingmeatforums for a while and have visited other websites too, but I always find myself coming back here so I’m signing up. I’ve been to alot of forums and I can honestly say I think this one...- baconisgood4me
- Thread
- Replies: 19
- Forum: Roll Call
-
