Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. a-bar

    First RF build, checking numbers

    Just have to remember a inch or so of RF plate can drop it more then one thinks in a pipe that size. You guys on here always say draw it on paper it does help . Thanks Dave Best Alan
  2. a-bar

    First RF build, checking numbers

    Something is wrong if you segment is 10.3 then thats about a third of  the CC and if your first grate is half you should have 4 to 5 inches between. Best Alan
  3. a-bar

    New RF Build

    Hi I'm not here often so maybe should not make any comment but with the tools you have available that stack could be moved to the other side and the old spot patched like it had never been there if you want a RF smoker. With a plasma and a mig welder and a little talent is all that's needed. I...
  4. a-bar

    my reverse flow build comments suggestions please

    shane I did a build and followed Daves # to a "T", so I would post a drawing with all your # and see if the pro's here can tell you the changes you need. Just my .02
  5. a-bar

    Order of Posts

    Smoke_Chef I hear ya this forum is twisted compared to any others I've been on. And do you all have to log off and then on to read new post. Alan.
  6. a-bar

    Smokers indoors

    mulepackin I used some alum. flex vent and chimney flashing from the UFA supply up here. Sorry I have to be short Internet is going to shut down need new provider. Alan.
  7. a-bar

    Thermostat questions

    trapper search the net for a Ranco Electronic thermostat they can set the cutin cutout 1to 30deg. I had more for you but my Internet it going down and lost it so sorry till I find a new provider. Alan. PS. If your 240v keep in mind to check amps needed.
  8. a-bar

    Hi form Alberta

    Badss, I'm from near Torrington, Alberta - a little tiny place 20 miles or so straight east of Olds - between Red Deer and Calgary. Alan
  9. a-bar

    Hi form Alberta

    Thanks guys for the warm welcome trying to digest all that's here could be a full time job. And a thanks to Osage for the info. on a Ranco thermostat I will have good look at it the price is rite. Oh all you Canucks there will be more of us after I do some e-mailing to some close friends...
  10. a-bar

    Hi form Alberta

    Hi everyone, came across your site searching for info. on a thermostat for a 1500 watt element in a freezer smoker I'm building. The hunt is slow calving up here now so can only pop in from time to time any help would be grate. Thanks for your time Alan.
Top Bottom
Back
Clicky