Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Search results
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
If you have not done this your problem is probably damp pellets.
the amount of pellets you are going to use need dried in a microwave for one minute do it two or three times I do it two times everytime I smoke something Good Luck!
Thanks "Piney" ! living in the past is frustrating but I really enjoy the present and my plans for next week!
Thanks again for every response from all of you
My goodness Pineywoods, last time we communicated you didn't have all of those six ribbons on your id. great to hear from you again. Have you seen anything of "Meowy"
I joined SMF in 2006 and have watched it go through a lot of growing and upgrading. Don't log on very much but remembered today when Jeff was asking for shorter names that I offered MES for masterbuilt electric smokers. See that it is still being used today! I am 83 years old and still...
Dorchester is not far from Virden where I live...
Although Both of my 40" Mes are in a heated building I do the following occasionally:
Leave the top vent closed and the chip loader all the way in when doing this.
Set the timer for 30 minutes and set the temp to 250 degrees. and let it run...
Thanks Craig,
When the Calrod is glowing red hot and the heat is migrating out to where the spade lug used to be I am wondering what the temp is at the solder joint Possibly 361 degrees or higher?
Enjoyed the joking around but on a practical view I wonder if this is a viable alternative to replacing spade lugs. There are three MES's in my arsenal and I have replaced at least one spade lug on two of them at times. I wonder if anyone in SMF land has had a long term experience with...
I have heard of this being done before. There has never been a follow up on how long the solder repair lasts. Seems that the temperature generated by the heater would be sufficient to melt the solder off of the terminals. Has anyone looked at a solder repair after it has been used to see...
Left click on the wrench in the upper right corner of chrome. Then in the drop down window left click on ABOUT GOOGLE CHROME. The next window will tell you if you are up to date or immediately will start updating to new version. If it is updating just wait and you will be asked to click one more...
Your Strami looks great Meowey even though you seem to have left out the "Vaporized Bourbon" that you were famous for.
I am still hanging around here and observing the proceedings.
Take care!!
Try this www.masterbuilt.com
Click on "Contact" in upper right hand corner.
I think the cajun injector and the MES are in most cases the same. The racks should interchange
It will never pull easier than when you take it out of the cooler hot!
Pull it and bag it in baggies then refridgerate it .
Tomorrow you can reheat it in the baggies in a pan that has lightly boiling water.
Do not allow the top of the bags to become submerged.
Alternately; after it is...
The cleaned off sensor in your photo is the high limit sensor.
The uncleaned sensor in your photo at the upper left corner is the temp sensor.
your confusion comes from the fact that the newer models have the temp sensor just under the second rack on the right side.
the new location lowers...