Recent content by enoshixi

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. enoshixi

    MES Cold Smoker Question

    Yes exactly. The tube is resting directly on the element and that causes the flange to rest above the groove, rather than in it. Not the easiest to take a picture of but I'll give it a shot.
  2. MES Cold Smoker Question

    MES Cold Smoker Question

  3. image.jpg

    image.jpg

  4. image.jpg

    image.jpg

  5. enoshixi

    MES Cold Smoker Question

    Wow I've been visiting this forum for years, didn't realize I'd never posted before! I do have an AMNPS also. To be honest I don't have quite the same luck with it as everyone else here seems to, but don't want to derail the thread with that.
  6. enoshixi

    MES Cold Smoker Question

    I recently bought the cold smoker attachment for my MES and set it up for the first time today. Something doesn't seem quite right though; is the wood chip tube supposed to rest flush in the groove inside the body of the unit? When the chip screen is on mine, the tube rests directly on top of...
Clicky