Recent content by dva

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. dva

    Backwoods Smoker Clone

    The sides are welded in and water pan is in place and only small drip on the drain pipe that I still need to fix. The smoke stack is tacked in place and was inspected by my helper: Prior to installing the outer sheeting, I need to finish welding in the smoke stack, install some supports for...
  2. dva

    Backwoods Smoker Clone

    More pics Back of cooking chamber tacked in (14 guage) hot rolled steel. This is not the best material but could not pass this up because it was only $0.40 per pound. Water pan was aligned. I also used the sides to align the waer pan but do not have picturs of using the sides of the cooking...
  3. dva

    Backwoods Smoker Clone

    I started my Backwoods Smoker clone last week. I have a UDS and decided it was time for a new project. The smoker was sized after the Competitor, Cooking chamber 20X20X29 [in], with 8 cooking racks spaced 3 [in]. The build has gone good so far and has been a lesson in welding. Prior welded...
Clicky