Design questions. I'm getting ready to make cuts.
Does it mater which end the drain is on?
My tank has a hole that is in the perfect location for the drain, But it also happens to be at the end I was thinking of putting the firebox. Only reason is whoever cut the motor off did a poor job then tried to weld who knows what to the top. I was going to simply cut off a side and then use steel plate to close it up again. Essentially making one end flat. I'm even considering doing a "deluxe" style with a warmer.
How big do I make the door?
Width is not a problem so much but height is. Do you do roughly 1/4 of the tank? Overall diameter is about 21-22 inches.
Finally, can anyone give me some help with the calculator? It's simple for the most part the difficulty is figuring the opening for the fire box.
I've got a 60 gallon air compressor tank if it makes a difference.
Sent from my GT-N7000 using Tapatalk
Does it mater which end the drain is on?
My tank has a hole that is in the perfect location for the drain, But it also happens to be at the end I was thinking of putting the firebox. Only reason is whoever cut the motor off did a poor job then tried to weld who knows what to the top. I was going to simply cut off a side and then use steel plate to close it up again. Essentially making one end flat. I'm even considering doing a "deluxe" style with a warmer.
How big do I make the door?
Width is not a problem so much but height is. Do you do roughly 1/4 of the tank? Overall diameter is about 21-22 inches.
Finally, can anyone give me some help with the calculator? It's simple for the most part the difficulty is figuring the opening for the fire box.
I've got a 60 gallon air compressor tank if it makes a difference.
Sent from my GT-N7000 using Tapatalk
Last edited:
