Power outage during smoking w electric smoker. Is the meat salvageable?

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

kdsbowl

Newbie
Original poster
Nov 20, 2011
3
10
I was set up for a nice low and slow smoke of a large pork shoulder on my electric smoker this evening and 4 hours into the process the power went out. Meat had reached an internal temp of 135 degrees. I didn't do anything to the smoker during the outage so there was some heat retained (The outside temp here in WI is about 35 degrees so I had it wrapped in a water heater blanket and covered in a moving blanket). Power is now back on but I am thinking the meat is no good. The internal temp of the meat dropped to 95 degrees. I hate to throw away $50 of meat but I also don't want to make everyone ill. Thoughts?
 
How long did it have heat before losing power, what temp where you cooking at before losing power, how long where you without power and did you inject the meat before putting it on the smoker?
 
If the Meat was at 135*F when the power went out...Carryover would have taken it over 145*F and Held it there for more than enough time to rendered it SAFE even with Injecting and Probing...Beyond that the Slow temp drop would have no effect...Fire it back up and finish the Job, Worry Free...JJ

FYI...Low Temp Long Time Pasteurization...Taking and Holding food items at 145*F for 30 Minutes or more...You would have gotten here in the above scenario...
 
Last edited:
It had heat for 4 hours. It was being smoked at 225 degrees. The power was out for 4 hours. The meat was injected with a fairly basic marinade of apple juice, sugar, salt and water.
 
The injection is the "sticking" point.   Injected meats should reach 140 degrees in 4 hours.  I don't think you achieved that.  If you are serving to a susceptible population (sick or old people, the general public) I would toss it.  If you are a young healthy person not in any risk groups that a stomach illness could cause a great deal of trouble then I would go with it.  I think it would fail a health inspection because according to the OP it did not reach 140 but if everything else was clean and germ free you shouldn't have any problems

Just curious,  did you bring your injection liquid to a boil before using and was the meat handled properly before going into the smoker?
 
Like JJ said, you should be good.

The 40˚ to 140˚ in 4 hours was actually changed to 41˚ to 135˚ in 4 hours, plus like JJ said, you had to have at least a little carryover. Then you did a wise thing and kept it insulated for those 4 hours, allowing it to only drop to 95˚. It should get back up to 140˚, and then to the finish in a short time. 

Fire that baby back up, and "git-er-done"!

Bear
 
I did not boil the injection liquid. I would consider the meat to have been properly handled prior to smoking, I am pretty meticulous about that. I am letting it run again while I monitor the posts. I figure I have about another 6 hours before I have to decide one way or another.
 
You should be ok, if you did indeed get to 135 internal you should be fine, enjoy your meal. 

"I believe in the 4 hour rule  41 to 135"  just so much easier remembering 40 - 140 after using it all these years 
icon14.gif


Al
 
If the Meat was at 135*F when the power went out...Carryover would have taken it over 145*F and Held it there for more than enough time to rendered it SAFE even with Injecting and Probing...Beyond that the Slow temp drop would have no effect...Fire it back up and finish the Job, Worry Free...JJ

FYI...Low Temp Long Time Pasteurization...Taking and Holding food items at 145*F for 30 Minutes or more...You would have gotten here in the above scenario...
X 2

Karl
 
 
You should be ok, if you did indeed get to 135 internal you should be fine, enjoy your meal. 

"I believe in the 4 hour rule  41 to 135"  just so much easier remembering 40 - 140 after using it all these years 
icon14.gif


Al
I totally agree with you, Al. I usually state the 40˚ to 140˚ myself.

I only mentioned the 41˚ to 135˚ because after the OP said his meat had reached 135˚, you replied, "Injected meats should reach 140 degrees in 4 hours.  I don't think you achieved that."

Just wanted to ease his mind.

Bear
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky