Calibrating the Maverick ET-732

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

iso

Smoke Blower
Original poster
Aug 16, 2007
113
10
Monroe, WA
Fired up my little smoker tonight to smoke up a pork butt. Box thermometer was working fine until I plugged in the meat probe. Temps went kind of haywire the meat probe was reading 100F at an air temp of about 55F. Tried my backup probe with the same effect.

Is there a way to calibrate the 732 so they are reading accurate?
 
Sounds like you might have gotten a bad one.

I would do a boil test with all probes, and write down the results.

Then you'll have some numbers to give Maverick, when you call them.

They have great service---They'll take care of you.

Bear
 
I think the guys above me have it right, not much more I can suggest.

Not to hijack the thread but can these be used in a deep fryer?
 
Send it back, and I'll deal with Maverick
TJ


Any more questions on why the guys here love ordering from Todd.   
thumb1.gif
 
Nope but I am curious if it can go in a deep fryer. ;)


Probably wouldn't hurt, if you could keep it from getting against the sides or bottom, and if you could keep the wire & the junction between the wire & the probe out of the oil.

There is no way I could do that in my deep fryer.

Bear
 
You sold me! I'm a new member here and after seeing this post I just ordered a et-732 from Tod myself. Good customer service means a lot to me.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky