Tube smoker lighting process?

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

weldin smoker

Newbie
Original poster
Dec 4, 2015
5
10
Southern California
Hey all,

New on here. Have a square tube smoker 16 inches long, with a 2 3/8 inside dimension I made quite a few years ago from some heavy perforated sheet. Only tried using it a couple times. Just wondering what process you use to light your tube smokers. I have both pellets and chips. What's everybody else using? Thanks for any advice. Going to try to do a 12lb turkey and 2 tri tips tomorrow in an old cabinet unit I got going yesterday.
 
Hey all,

New on here. Have a square tube smoker 16 inches long, with a 2 3/8 inside dimension I made quite a few years ago from some heavy perforated sheet. Only tried using it a couple times. Just wondering what process you use to light your tube smokers. I have both pellets and chips. What's everybody else using? Thanks for any advice. Going to try to do a 12lb turkey and 2 tri tips tomorrow in an old cabinet unit I got going yesterday.
Can we get a pic ,,,, I use a small propane torch and I only do pellets in my ampts 

A full smoker is a happy smoker 

DS
 
 
I'll get a pic in the morning. I light it with a propane torch as well for 30 seconds to a minute. This time I let it burn a little longer than usual, about 12 min. Seemed to work pretty well. That was at 5:00 pm, still a nice stream of light smoke. Tube was only about 1/4 full of hickory pellets.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky