Needle valve fitting issue (Smoke Hollow 38208G)

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

oda 564

Newbie
Original poster
Jun 14, 2014
5
10
When I bought my 38208G, I went ahead and bought a preassembled Bayou Classic 0-30 PSI Adjustible Regulator/Hose Assembly (), which has/a 3/8" inner diameter female fitting at the burner end. Apparently that's their standard fitting.

However, the Smoke Hollow has a visibly smaller fitting (1/2"? I didn't take it off) where the gas line connects to the burner control.

Is this something that's fixable or do I start over?
 
When I bought my 38208G, I went ahead and bought a preassembled Bayou Classic 0-30 PSI Adjustible Regulator/Hose Assembly (), which has/a 3/8" inner diameter female fitting at the burner end. Apparently that's their standard fitting.

However, the Smoke Hollow has a visibly smaller fitting (1/2"? I didn't take it off) where the gas line connects to the burner control.

Is this something that's fixable or do I start over?
Take accurate measurements then run to a hardware store or big box like Home Depot and find a step down fitting to connect the two.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky